Brass melting furnace for safe operation

Before opening brass melting furnace to check the good electrical equipment, water cooling systems, sensors and other brass is intact, otherwise prohibiting the opening of the furnace. Loss exceeds the melting furnace should be promptly repaired. Prohibited in the Induction forging furnace melt loss over the deep crucible melting. Power transmission and furnace should be the person responsible for the non-contact power transmission sensors and cables. On duty were not allowed to leave their posts, pay attention to external sensors and crucible situation. When charging, induction heat treatment the charge should be checked whether the explosive and other hazardous materials mixed in, if any should be removed and the wet cold material is strictly prohibited material directly into the molten steel, molten liquid filled after large pieces of material joined to the upper forbidden to anti-knot cover.When fettling and pound crucible non iron, iron oxide mixed, pound crucible must be dense. Front pouring induction heating equipment venues and pit should be no obstacles, no water, to prevent the molten steel floor explosion. Steel does not allow costumes too full, hand ladle pouring, the two should be consistent with the walk should be smooth, not allowed Jizou stop, after pouring more than steel to be poured into the designated locations, Dumping is strictly prohibited.